Description
Cables used to connect the PI S334 to the
BCU. Each piezo head has 5 cables terminated with LEMO connectors: 3 for the HV commands (Axis 1, Axis 2, 100V) and 2 for the strain gauges (Axis1 and Axis2). The 5 cables of each piezo head are connected to 5 pass-through connectors installed on the
ConnectorPanel of the LGSW unit. From the
ConnectorPanel a 6-m long, 5-cables bundle goes to the
BCU. The bundle is protected with a plastic wrinkling-tube.
List of devices of this kind
Documentation
Drawings are here:
Drawings of the steering mirrors cables. From GL elettronica 10 May 2011
Panel connectors are LEMO ABD.00.250.NTM (for the HV signals) and SWH.0S.304.CLLPV (for the strain gauges)
Installation and maintenance
The end with 5 LEMO connectors goes to the
BCU. The end with 3 BNC and 2 LEMO connectors goes to the
ConnectorPanel. The
ConnectorPanel is color coded: if, for instance, you are installing the cabling for the
BlueChannel, you should connect the cable to the 5 connectors encircled by the blue line. Pay close attention to not mix the axis!
On the
BCU side
The
BlueChannel is connected to the HVC board closer
Actuators and Sensors are numbered from 0 to 6. Connect actuators to 0,1,2 or to 3,4,5 accordingly to the label. Connect sensor to 0,1 or to 3,4 accordingly o the label o
Reference
This topic is referred in:
CablePiezoBCU0,
CablePiezoBCU1,
CablePiezoBCU10,
CablePiezoBCU2,
CablePiezoBCU3,
CablePiezoBCU4,
CablePiezoBCU5,
CablePiezoBCU6,
CablePiezoBCU7,
CablePiezoBCU8
Topic label
 |  |
CablePiezoBcu
|
aowiki.arcetri.astro.it/ARGOSPublic/CablePiezoBcu |