Description These are diaphragm pumps used to extract air from the EM shield in the LgswUnit where the PockelsCells are installed. These devices were added to the...
Description The servo switches are intended to choose, if the piezos are operated in open (off) or closed loop (on). Upper switch: X axis Lower switch:Y axis Doc...
Description Jitter compensation in the LGSW is done by piezo platform PI S334.1SL Documentation attach and describe datasheets and documents Installation and ma...
Known history First unit of S334.1SL purchased in June 2010, S/N 110032051, tested in Microgate in August 2010 and then "lost" in Microgate for a while. It has th...
Description The pneumatic dust shutter controller is a remote controlled device, which operates the dust shutter pneumatic cylinders. Known history When Wher...
Description This is the new model of PockelsCells rebuild after the OzoneProblem, upgraded to version 2.1 (see PockelsCells) Known history When Where Who ...
Description This is the new model of PockelsCells rebuild after the OzoneProblem, upgraded to version 2.1 (see PockelsCells) Known history When Where Who ...
Description This is the new model of PockelsCells rebuild after the OzoneProblem, upgraded to version 2.1 (see PockelsCells) Known history When Where Who ...
Description A device in the rack with an on off button and a potentiometer to adjust HV tension. This is an obsolete model, it has been upgraded in Jun 2015. See ...
Description A device in the ElectronicRackLgsw to supply high voltage to the PockelsCellDriverV2. This is a replacement of PockelsCellAmplifier, in operation sinc...
Power up, set up, ramp voltage, start up commands argos@sx lgsw the_pcd $ ./the_pcd.sh ARGOS THE POCKELS CELL DRIVER Missing command parameters. Use B0,B1,B2,B3...
Description This device is installed on a side of the LgswUnit. This is an obsolete device, replaced by PockelsCellDriverV2 Documentation attach and describe dat...